Walkputer: where it stands and what's next
Walkputer now builds its own software on the device. Here's the state of the software and the hardware, and the roadmap to the first release and beyond.
Walkputer is a pocket computer fantasy console that runs on microcontrollers like the Raspberry Pi Pico. Programs are written and compiled on the device itself, with a D-pad and buttons instead of a keyboard.
Software
Its own compiler. Walkputer's programs were first written in C and compiled with GCC on a computer. Now the device has its own compiler, so programs are written and built on the Walkputer itself. That compiler already builds the code editor, every app in the system, and its own source: everything on a Walkputer can now be rebuilt on a Walkputer.
The editor. The code editor shows a program as a tree of code rather than lines of text, and you change it by picking from menus that know what fits where.
The system. Wapucore, the core of the system, runs programs and handles graphics, sound and files. Its file system on the SD card is copy-on-write, so a crash or a pulled battery can't leave a file half-written.
The emulator. Walkputer also runs on a computer, in a desktop emulator and in a web one, so programs can be tried without a device. The web one will be the first part of Walkputer anyone can try (see the roadmap below).
Hardware
Walkputer runs on the RP2350, the chip in the Raspberry Pi Pico 2: two Arm cores at 150 MHz and 520 KB of RAM. For now it runs only on Arm; RISC-V is planned. It comes in two builds, and the same firmware runs on both — the settings for each board are loaded when it starts.
The DIY shield. A shield for Waveshare's RP2350 module, which already has the screen and the SD card slot. The shield adds the D-pad and buttons, and a few things the module lacks. It's a single PCB: you have it made from the design files at a PCB fab, then connect it to the module. It comes first.
The Walkputer board. A fully integrated board: everything on one board, in Walkputer's own form factor. It's in progress.
Roadmap
- Emulator public preview. The web emulator goes public, so anyone can try Walkputer in the browser before there's hardware to build.
- DIY shield release. The firmware to flash to the module, the shield's design, and the guides that go with them: setting up the device, building the software, and assembling the shield.
- Walkputer board release. The fully integrated board.
Walkputer will be open source, the software and the hardware alike. Both builds are being designed so that you can take the design files to a PCB manufacturing service and have the boards made yourself. An official prebuilt Walkputer might follow in the future.